Mix N' Match - Pick any 2 modules from our Catwalk Series from the menu to mix and match to suit your taste. Waveform Catwalk modules take up no HP by attaching to your Eurorack system over top of existing modules, where they rise above the faceplates of the modules they're over top of so there's no contact with the modules below other than the screw holes where the standoffs are.
Choose from:
The Catwalk Mult: These are 1 in 3 out mults that copy (or "mult") your signal. The mounting holes are approx. 60mm long and perfectly span 14HP modules. Easy to build, useful, and with a picture of a cat, what more could you want? The instructions on how to build this are detailed in issue #4 and can also be found on our Build Guide page. Faceplate is black with silver and is reversible if you want no cats in your rig.
The Catwalk Cattenuator: These are passive attenuators and the mounting holes spanabout 50mm and this fits perfectly over the top of a 10HP module and a neighboring module. These are very easy to build, and are extremely handy. The instructions on how to build this are detailed in issue #5 and can also be found on our Build Guide page. Faceplate is black with silver.
The Catwalk LPG/VCA*:These can either be a Low Pass Gate or Voltage Controlled Amplifier (actually, since it's passive, it's an attenuator NOT an amplifier), and the faceplate is reversable to show if it's a VCA or LPG. These are pretty easy to build, though it does take some maneuvering to get the parts to fit right. The instructions on how to build this are detailed in issue #5 and can also be found on our Build Guide page. Faceplate is black with silver. The Catwalk LPG/VCA is 75mm in length and the screw holes fit over approx. 16 HP.
*When ordering the Mix N' Match version of the LPG/VCA it will come with a LPG by default. Please email us if the VCA is desired instead.
The Catwalk Switch/Mute:These care 2 in, 1 out (or 2 out, 1 in) and allow you to use one input and switch it between two different outputs, or to switch between two inputs to go to one output, all by the flick of a switch! With the switch in the middle position this turns into a mute, perfect for those quiet times. The mounting holes span about 67mm and this fits perfectly over the top of a 16HP module. These are very easy to build, and are extremely handy. The instructions on how to build this can be found on our Build Guide page. Faceplate is black with silver.
KIT AND ASSEMBLED VERSIONS COME WITH A TOTAL OF TWO MODULES.
Note: These come with M3 screws and standoffs.
